132991640.qxd 06/10/2003 17:08 Pagina 6 (Nero/Process Black pellicola)
The Control Panel
-
-
---
-
-
-
1 Detergent dispenser drawerThe delay start can not be selected with SPIN and
DRAIN programmes.
Programme Option buttons
3 Rinse Hold button
Depending on the programme, different functions can
be combined. These must be selected after choosing the
When selecting this option the water of the last rinse is
desired programme and before depressing the ?start
not emptied out, to prevent the fabrics from creasing.
pause? button.At the end of the programme the pilot lights ?door? and
When these buttons are pressed, the corresponding pilot?end? illuminate. To drain water, proceed as follows:
lights come on. When they are pressed again, the pilot
Iturn the programme selector dial to position ?O?;
lights go out.
Iselect programme 8 (drain) or 7 (spin). In this case
If an incorrect option is selected, the corresponding
reduce the spin speed by means of the relevant
pilot light flashes for about 2 seconds.
button to adapt it to the fabrics to be spun.
Ipress ?start pause? button.
2 8 H and 4 H button
You can press this button to delay the start of the
4 Spin Reduction button
washing programme by 8 or 4 hours. The delay you
have selected is indicated by the illumination of the
By selecting this option the speed will be reduced as
corresponding light.
follows:
You must select this option after you have set the
Cotton: from 1500 to 700 r.p.m. and from 1200 to 600
programme and before you press the START
r.p.m.
PAUSE button.
Synthetics, wool and handwash: from 900 to 450
You can cancel the delay time at any moment, before
r.p.m.
you press the START/PAUSE button.
Delicates: from 700 to 450 r.p.m.
If you have already pressed the START/PAUSE button,
and you wish to cancel the delay time, proceed as
5 Half Load button
follows:
Select this button to reduce water consumption on the
? set the washing machine to PAUSE by pressing the
rinse cycle when washing a smaller load of cottons or
START/PAUSE button;
linens (maximum load size = 3 kg).
? press the DELAY button once, the light relevant to the
The machine will perform 2 rinses instead of 3.
selected delay goes off .
? press the START/PAUSE button again to start the
6 Start Pause button
programme.
Important!After having selected the required programme, press
this button to start the machine; the corresponding pilot
IThe selected delay can be changed only after
light stops flashing.
selecting the washing programme again.
To interrupt a programme which is running, depress the
IThe door will be locked throughout the delay time.
?start pause? button: the corresponding pilot light starts
If you need to open the door, you must first set theto flash.
washing machine to PAUSE by pressing the
To restart the programme from the point at which it was
START/PAUSE button. After you have closed the
interrupted, press the ?start pause? button again.
door, press the START/PAUSE button again.
6 |
ACEC
